Share Email Print
cover

Proceedings Paper

New structure of ArF high-transmittance attenuated phase-shifting mask with dry etching process
Author(s): Hiroyuki Iso; Noriyuki Harashima; Tatsuya Isozaki; Shuichiro Kanai; Takaei Sasaki
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

ULVAC Coating Corporation proposes a new ArF high transmittance attenuated mask which consists of a thin MoSiON film and a quartz trench. We made an appropriate thickness MoSiON film and found a proper dry etching condition to dig a quartz trench by a NLD dry etcher. The etched quartz trench had very smooth bottom and correct depth. It is very difficult to make ArF high transmittance attenuated mask with perfectly satisfy the transmittance and phase shift angle because of characteristics of MoSiON film. PSM with MoSiON film has been used commercially under 248nm and 193nm wavelength. If it is possible to use the current MoSiON film also for ArF high transmittance attenuated mask making, it would be very convenient for mask makers. This report will show our investigation results in regards to the possibility of making ArF high transmittance attenuated mask by using current MoSiON film with setting the transmittance of 15% at 193nm wavelength and setting the phase shift angle of 180 degree by MoSiON film and quartz trench etching. NLD (Magnetic Neutral Loop Discharge) mask etcher was used for this investigation. At conventional conditions, a large side etch was observed on the MoSiON film as a result of the etching process. We checked correlation between gas pressure and side etch, and found lower pressure resulted in smaller side etch. As the further low pressure, appearance of sub-trench were observed. By adding a CxFy gas with CF4-base etching gas for the dry etching process, we are able to improve the side etching and also sub-trench.

Paper Details

Date Published: 6 December 2004
PDF: 6 pages
Proc. SPIE 5567, 24th Annual BACUS Symposium on Photomask Technology, (6 December 2004); doi: 10.1117/12.579067
Show Author Affiliations
Hiroyuki Iso, ULVAC Coating Corp. (Japan)
Noriyuki Harashima, ULVAC Coating Corp. (Japan)
Tatsuya Isozaki, ULVAC Coating Corp. (Japan)
Shuichiro Kanai, ULVAC Coating Corp. (Japan)
Takaei Sasaki, ULVAC Coating Corp. (Japan)


Published in SPIE Proceedings Vol. 5567:
24th Annual BACUS Symposium on Photomask Technology
Wolfgang Staud; J. Tracy Weed, Editor(s)

© SPIE. Terms of Use
Back to Top