Share Email Print
cover

Proceedings Paper

Spectrally resolved thermoluminescence data analysis by surface fitting
Author(s): Arkadiusz Mandowski; Ewa Mandowska; Jozef Swiatek
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

Typical analysis of thermoluminescence (TL) data is based on various curve fitting algorithms. Older methods used merely several characteristic points of TL curves as the peak position, inflection points or peak width. This approach is generally not suitable for advanced TL measurements utilizing simultaneous detection of wavelength and intensity of the emitted light. These data are represented in the form of surface in three dimensional coordinates. Spectrally resolved thermoluminescence (TL-3D) contains a lot of information concerning both trapping and recombination states. This new technique requires a novel theoretical approach for extracting from experimental data as much information as possible. In this paper we present new algorithm that we call the 'surface fitting.' TL-3D surface is numerically deconvoluted for individual peaks corresponding to trap levels and recombination centres. To demonstrate possibilities of the method we applied the algorithm to the analysis of TL-3D data of some thermoluminescence detectors based on LiF:Mg luminophor.

Paper Details

Date Published: 22 October 2003
PDF: 6 pages
Proc. SPIE 5136, Solid State Crystals 2002: Crystalline Materials for Optoelectronics, (22 October 2003); doi: 10.1117/12.519744
Show Author Affiliations
Arkadiusz Mandowski, Pedagogical Univ. of Czestochowa (Poland)
Ewa Mandowska, Pedagogical Univ. of Czestochowa (Poland)
Jozef Swiatek, Pedagogical Univ. of Czestochowa (Poland)


Published in SPIE Proceedings Vol. 5136:
Solid State Crystals 2002: Crystalline Materials for Optoelectronics
Jaroslaw Rutkowski; Antoni Rogalski, Editor(s)

© SPIE. Terms of Use
Back to Top