Share Email Print
cover

Proceedings Paper

Modified sol-gel derived PZT ceramics
Author(s): S. A. Ibrahim; M. S. Ahmed; R. M. Ramadan; Adel M Amer
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

An improved method is described for the sol-gel preparation of PZT ceramics in the perovskite structure. This method uses acetic acid as a solvent. Details are reported for the modified sol-gel processing route and heat-treatment conditions. By using this method it is possible to prepare single perovskite material with improved properties. The deleterious effect of additional phases is attributed to Pb loss from the surface during thermal processing. The density of the PZT pellets is observed to decrease as the sintering time increases. A ninety-seven percent theoretical density is obtained for samples sintered at 950°C for two hours. The dielectric properties of the PZT are measured and compared with unmodified sol-gel.

Paper Details

Date Published: 24 April 2003
PDF: 9 pages
Proc. SPIE 5116, Smart Sensors, Actuators, and MEMS, (24 April 2003); doi: 10.1117/12.488346
Show Author Affiliations
S. A. Ibrahim, Suez Univ. (Egypt)
M. S. Ahmed, Suez Univ. (Egypt)
R. M. Ramadan, Suez Univ. (Egypt)
Adel M Amer, Suez Univ. (Egypt)


Published in SPIE Proceedings Vol. 5116:
Smart Sensors, Actuators, and MEMS
Jung-Chih Chiao; Vijay K. Varadan; Carles Cané, Editor(s)

© SPIE. Terms of Use
Back to Top