Share Email Print
cover

Proceedings Paper

Dynamic modeling and control of rectangular plate with piezoceramic sensors and actuators
Author(s): Moon K. Kwak; Seok Heo; Myeong-Il Lee
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

This paper is concerned with the modeling of the rectangular plate bonded with rectangular piezoceramic sensors and actuators, which can have an arbitrary angle with respect to the plate axis. The equations of motion were derived by the Rayleigh-Ritz method. The cantilever plate with piezoceramic sensors and actuators was built to verify the theoretical development. The theoretical frequency response curve based on the equations of motion was then compared to the experimental frequency response curve. The sensor and actuator characteristics were also studied both theoretically and experimentally. The sensor characteristic is defined as the ratio of the tip displacement to the voltage output and the actuator characteristic is defined as the ratio of the applied voltage to the tip displacement. The final objective of the research is to optimize the sensor and actuator locations as well as orientation to maximize the control performance. The control performance will follow.

Paper Details

Date Published: 1 August 2003
PDF: 10 pages
Proc. SPIE 5049, Smart Structures and Materials 2003: Modeling, Signal Processing, and Control, (1 August 2003); doi: 10.1117/12.482821
Show Author Affiliations
Moon K. Kwak, Dongguk Univ. (South Korea)
Seok Heo, Dongguk Univ. (South Korea)
Myeong-Il Lee, Dongguk Univ. (South Korea)


Published in SPIE Proceedings Vol. 5049:
Smart Structures and Materials 2003: Modeling, Signal Processing, and Control
Ralph C. Smith, Editor(s)

© SPIE. Terms of Use
Back to Top