Share Email Print
cover

Proceedings Paper

High-speed drilling of metals with a long-pulse XeCl excimer laser
Author(s): Aart Schoonderbeek; Cornelis A. Biesheuvel; Ramon M. Hofstra; Klaus-Jochen Boller; Johan Meijer
Format Member Price Non-Member Price
PDF $14.40 $18.00
cover GOOD NEWS! Your organization subscribes to the SPIE Digital Library. You may be able to download this paper for free. Check Access

Paper Abstract

Studies of the influence of pulse length on material processing with different lasers have shown that a long pulse is beneficial for processing speed. In this paper a technique of pulse length variation is used in which the pulse length is the only varied parameter. Pulses between 5 and 150 ns length are sliced out of the 175 ns pulse of a long pulse excimer laser. The beam quality for each sliced pulse length is similar. In this paper the results are shown of hole drilling experiments in 125 micron aluminium foil with pulses of 10 and 100 ns length. The influence of the pulse length on material processing is discussed in relationship with equal energy and equal power density of the pulses. This study shows that in both cases long pulses remove more material than short pulses.

Paper Details

Date Published: 13 September 2002
PDF: 11 pages
Proc. SPIE 4760, High-Power Laser Ablation IV, (13 September 2002); doi: 10.1117/12.482139
Show Author Affiliations
Aart Schoonderbeek, Nederlands Ctr. voor Laser Research B.V. (Netherlands)
Cornelis A. Biesheuvel, Nederlands Ctr. voor Laser Research B.V. (Netherlands)
Ramon M. Hofstra, Nederlands Ctr. voor Laser Research B.V. (Netherlands)
Klaus-Jochen Boller, Univ. Twente (Netherlands)
Johan Meijer, Univ. Twente (Netherlands)


Published in SPIE Proceedings Vol. 4760:
High-Power Laser Ablation IV
Claude R. Phipps, Editor(s)

© SPIE. Terms of Use
Back to Top