Share Email Print

Proceedings Paper

Electronic readout of a-Si EPIDs for optimum signal-to-noise ratio
Author(s): Farhad A. Ghelmansarai; Satrajit Misra; Jean Pouliot
Format Member Price Non-Member Price
PDF $14.40 $18.00
cover GOOD NEWS! Your organization subscribes to the SPIE Digital Library. You may be able to download this paper for free. Check Access

Paper Abstract

Three acquisition schemes for a-Si flat panels are described for radiation therapy imaging. The goal of all three acquisition modes is to acquire images with the highest achievable SNR (signal to noise ratio). The acquisition modes are Single mode for low dose acquisition (used for patient positioning), external continuous mode used for patient treatment (verification), and Cone Beam mode for mega-voltage computed tomography (MVCT). During single mode acquisition, a few frames are readout prior to the start of irradiation. During this cycle, the accumulated dark current and residual data are cleared. During the radiation delivery no readout occurs, and the signal is integrated over the entire exposure period. After the irradiation readout occurs. The advantages of this readout scheme are to reduce the effects of readout noise and eliminate the linear accelerator (linac) pulsing effects on the final image. There is no readout during the exposure; therefore, no beam pulsing artifacts occur. Since the signal is integrated during the exposure time and the readout is performed after the exposure, this improves the SNR compared to acquiring a few frames during the radiation and averaging these frames to create the final image. The single mode acquisition is used clinically routinely and allows the acquisition of clinical images with a small amount of exposure (<=2 MU). During external trigger continuous mode, the linear accelerator pulsing artifacts are removed by synchronizing the frame readout with linear accelerator pulses. The pulsing artifacts reduce the signal to noise ratio. This degradation is in the range of 70% for a single frame acquisition with 6MV, 300MU/min X-ray beam. Frame averaging reduces the degradation. The Cone beam acquisition mode is used to perform volume MVCT in the cone beam geometry to visualize 3D (three dimensional) anatomy during patient positioning. In this mode the image acquisition is synchronized with the linear accelerator, which enables the imager to remove linear accelerator pulsing artifacts from the image and also provides the charge integration during low dose imaging. This synchronization improves the SNR.

Paper Details

Date Published: 5 June 2003
PDF: 11 pages
Proc. SPIE 5030, Medical Imaging 2003: Physics of Medical Imaging, (5 June 2003); doi: 10.1117/12.480481
Show Author Affiliations
Farhad A. Ghelmansarai, Siemens Medical Solutions, Inc. (United States)
Satrajit Misra, Siemens Medical Solutions, Inc. (United States)
Jean Pouliot, Univ. of California/San Francisco (United States)

Published in SPIE Proceedings Vol. 5030:
Medical Imaging 2003: Physics of Medical Imaging
Martin J. Yaffe; Larry E. Antonuk, Editor(s)

© SPIE. Terms of Use
Back to Top