Share Email Print
cover

Proceedings Paper

Dissolution performance of device pattern with low-impact development
Author(s): Shinichi Ito; Kei Hayasaki; Hiroko Nakamura
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

For low-k1 lithography, high accurate control of the development process is required. For that purpose, low- impact dispensing is one of the most effective approaches. In that process, development time differs between start and end position of nozzle-scan. To reduce the time lag, the nozzle-scan-speed of 140mm/s was selected. But critical dimensions (CD) offset that depends on scan-direction was detected. From the results of the CD and dissolution performances for three resists, we found that the pull-back flow of the developer was the main cause of the CD offset. Thus, it is important that the developer does not flow by its pull-back-force. By observing and analyzing the flow of the dissolution product with a video camera, the best condition of the scan-speed (=60 mm/s) was selected. Under this nozzle-scan condition, the dissolution rates did not depend on the scan-direction of the dispenser-nozzle. As a result, the small CD offset could be observed for 200nm L&S patterns.

Paper Details

Date Published: 24 August 2001
PDF: 8 pages
Proc. SPIE 4345, Advances in Resist Technology and Processing XVIII, (24 August 2001); doi: 10.1117/12.436900
Show Author Affiliations
Shinichi Ito, Toshiba Corp. (Japan)
Kei Hayasaki, Toshiba Corp. (Japan)
Hiroko Nakamura, Toshiba Corp. (Japan)


Published in SPIE Proceedings Vol. 4345:
Advances in Resist Technology and Processing XVIII
Francis M. Houlihan, Editor(s)

© SPIE. Terms of Use
Back to Top