Share Email Print
cover

Proceedings Paper

X-ray zone plate fabrication using a focused ion beam
Author(s): Peter P. Ilinski; Barry P. Lai; Neil J. Bassom; Jason Donald; Gregory J. Athas
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

An x-ray zone plate was fabricated using the novel approach of focused ion beam (FIB) milling. The FIB technique was developed in recent years, it has been successfully used for transmission electron microscopy (TEM) sample preparation, lithographic mask repair, and failure analysis of semiconductor devices. During FIB milling, material is removed by the physical sputtering action of ion bombardment. The sputter yield is high enough to remove a substantial amount of material, therefore FIB can perform a direct patterning with submicron accuracy. We succeeded in fabricating an x-ray phase zone plate using the Micrion 9500HT FIB station, which as a 50 kV Ga+ column. Circular Fresnel zones were milled in a 1.0-micrometer-thick TaSiN film deposited on a silicon wafer. The outermost zone width of the zone plate is 170 nm at a radius of 60 micrometer. An achieved aspect ratio was 6:1.

Paper Details

Date Published: 5 January 2001
PDF: 6 pages
Proc. SPIE 4145, Advances in X-Ray Optics, (5 January 2001); doi: 10.1117/12.411652
Show Author Affiliations
Peter P. Ilinski, Argonne National Lab. (United States)
Barry P. Lai, Argonne National Lab. (United States)
Neil J. Bassom, FEI Corp. (United States)
Jason Donald, FEI Corp. (United States)
Gregory J. Athas, FEI Corp. (United States)


Published in SPIE Proceedings Vol. 4145:
Advances in X-Ray Optics
Alan G. Michette; Andreas K. Freund; Tetsuya Ishikawa; Sebastian Oestreich; Derrick C. Mancini; Ali M. Khounsary; Derrick C. Mancini; Alan G. Michette; Sebastian Oestreich, Editor(s)

© SPIE. Terms of Use
Back to Top