Share Email Print
cover

Proceedings Paper

Influence of workpiece support on the generated surface in turning
Author(s): Abdelkader A. Ibrahim; A. M. A. Soliman; H. A. Housin
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

The tailstock is used in turning operation to guide the workpiece rotation. This paper introduces an investigation for the influences of the tailstock axial force on the turning dynamics. A set of experiments were carried out to study the effect of different axial clamping force on the vibration of the tool- workpiece system and consequently on the workpiece roundness error. Vibrations generated during turning were measured in three directions (radial, axial, and tangential). Moreover, the resulted roundness errors on the workpieces surfaces were also measured. The results showed a great dependence of both vibrations existing during turning and the resulted roundness error, on the tailstock axial clamping force. The control of this force will improve the workpiece quality and detect the other errors such as chuck clamping. There is an optimum value for this force that reduces the roundness error to a minimum value. Also the vibration signals in the axial direction correlates comparatively well with the tailstock clamping force than those in other directions.

Paper Details

Date Published: 13 October 2000
PDF: 8 pages
Proc. SPIE 4192, Intelligent Systems in Design and Manufacturing III, (13 October 2000); doi: 10.1117/12.403682
Show Author Affiliations
Abdelkader A. Ibrahim, Zagazig Univ. (Egypt)
A. M. A. Soliman, Elmenya Univ. (Egypt)
H. A. Housin, Benha Higher Institute of Technology (Egypt)


Published in SPIE Proceedings Vol. 4192:
Intelligent Systems in Design and Manufacturing III
Bhaskaran Gopalakrishnan; Angappa Gunasekaran, Editor(s)

© SPIE. Terms of Use
Back to Top