Share Email Print
cover

Proceedings Paper

Manufacturing of optical elements of a cryogenic optical system
Author(s): Mangzuo Shen; Xiangdi Lin; Wenli Ma; Sheng Liao
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

Cryogenic optical system undergoes wide temperature change; therefore it must be athermal. That means when the system is cooled down to very low temperature, its imaging property should be kept as good as at room temperature. One way to achieve athermal optical system requires that all optical and mechanical parts in the system be made from same material. An all-reflective cryogenic optical system was thus developed in IOECAS, in which aluminum alloy was utilized to make such a system. This paper describes the key techniques for manufacturing this cryogenic optical system: material selection, forging process of the aluminum alloy blanks, initial machining, heat treatments, and final figuring. The cryogenic test of the developed system proved the validity of the manufacturing process.

Paper Details

Date Published: 6 October 2000
PDF: 4 pages
Proc. SPIE 4231, Advanced Optical Manufacturing and Testing Technology 2000, (6 October 2000); doi: 10.1117/12.402744
Show Author Affiliations
Mangzuo Shen, Institute of Optics and Electronics (China)
Xiangdi Lin, Institute of Optics and Electronics (China)
Wenli Ma, Institute of Optics and Electronics (China)
Sheng Liao, Institute of Optics and Electronics (China)


Published in SPIE Proceedings Vol. 4231:
Advanced Optical Manufacturing and Testing Technology 2000
Li Yang; Harvey M. Pollicove; Qiming Xin; James C. Wyant, Editor(s)

© SPIE. Terms of Use
Back to Top