Share Email Print
cover

Proceedings Paper

Evaluation of fine pattern definition with electron-beam direct writing lithography
Author(s): Tsann-Bim Chiou; Peter Hahmann; Ming-Chi Liaw; Tiao-Yuan Huang; Simon M. Sze
Format Member Price Non-Member Price
PDF $14.40 $18.00
cover GOOD NEWS! Your organization subscribes to the SPIE Digital Library. You may be able to download this paper for free. Check Access

Paper Abstract

Electron beam (e-beam) lithography is one of the potential candidates for defining fine patterns smaller than 100 nm. To increase throughput, variably shaped beams with vector scan and cell projection techniques have been proposed on the e- beam system. In order to achieve high pattern fidelity in the e-beam lithography special care must be taken with respect to effects, that could result from shot-to-shot, subfield-to- subfield, and stripe boundaries. The key considerations on the pattern fidelity are dimension control and edge roughness. In this paper, methods to enhance pattern fidelity are proposed and discussed. A Leica's WEPRINT 200 system (Leica Microsystems Lithography GmbH), which exerts exposure while continuously moving the stage technique to increase throughput, is used for evaluating the effectiveness of these methods. For the dimension uniformity, the important task is to master shot butting, subfield and stripe stitching and counteract the proximity effects. By employing beam sizing for proximity effect correction and double-pass exposure to suppress stitching error, the dimension variation is largely eliminated. Several factors including accelerating voltage, beam size, proximity effect, beam blur due to Coulomb interaction, and process controllability are found to affect the CD accuracy. To improve the CD accuracy, pattern-bias compensation and proximity effect correction methods are employed in 0.1 micrometer range and below. Good results on dimension accuracy are obtained by properly considering the intra- and inter-proximity effects. Finally, the performance comparison between these methods is discussed.

Paper Details

Date Published: 21 July 2000
PDF: 12 pages
Proc. SPIE 3997, Emerging Lithographic Technologies IV, (21 July 2000); doi: 10.1117/12.390104
Show Author Affiliations
Tsann-Bim Chiou, National Nano Device Labs. (Taiwan)
Peter Hahmann, Leica Microsystems Lithography GmbH (Germany)
Ming-Chi Liaw, National Nano Device Labs. (Taiwan)
Tiao-Yuan Huang, National Nano Device Labs. (Taiwan)
Simon M. Sze, National Nano Device Labs. (Taiwan)


Published in SPIE Proceedings Vol. 3997:
Emerging Lithographic Technologies IV
Elizabeth A. Dobisz, Editor(s)

© SPIE. Terms of Use
Back to Top