Share Email Print

Proceedings Paper

Ridge waveguide Mach-Zender modulators fabricated by a novel nickel-indiffused LiNbO3 self-aligned process
Author(s): Wen-Ching Chang; Chao-Yung Sue; Hung-Ching Hou; Ming-Yung Hsuan; Li-Ying Chang
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

Traditionally, there were two fabrication processes for LiNbO3 ridge waveguides, which were nickel (Ni) diffusion prior to PE wet etch, the DE process, and PE wet etch prior to Ni diffusion, the ED process. Though these processes have been optimized and are much better than the dry etch methods, further improvement is necessary. This is because the former easily result in unwanted planar waveguides flanking the ridge structures, while the latter requires relatively complicated process. In this paper, a novel self-aligned fabrication process for Ni:LiNbO3 ridge waveguides has been proposed. By using the self- aligned tri-layered structure composed of Ni/Ti/Si, the fabrication process is significantly simplified. Based on our observations, the deposited thickness of the self- aligned structure will determine the qualities of the ridge waveguides. Moreover, the novel self-aligned fabrication process was applied to fabricate a ridge waveguide Mach- Zehnder modulator. The measured half-wave voltage and extinction ratio were 20.5V and 12dB, and were 4.2V and 8dB.

Paper Details

Date Published: 24 March 2000
PDF: 8 pages
Proc. SPIE 3936, Integrated Optics Devices IV, (24 March 2000); doi: 10.1117/12.379965
Show Author Affiliations
Wen-Ching Chang, Tamkang Univ. (Taiwan)
Chao-Yung Sue, Tamkang Univ. (Taiwan)
Hung-Ching Hou, Tamkang Univ. (Taiwan)
Ming-Yung Hsuan, Tamkang Univ. (Taiwan)
Li-Ying Chang, Tamkang Univ. (Taiwan)

Published in SPIE Proceedings Vol. 3936:
Integrated Optics Devices IV
Giancarlo C. Righini; Seppo Honkanen, Editor(s)

© SPIE. Terms of Use
Back to Top