Share Email Print
cover

Proceedings Paper

Dry etch yield enhancement by use of after-develop inspection
Author(s): Franklin D. Kalk; Keith J. Brankner; Lori Peters; Anthony Vacca; Scott Pomeroy; David Emery
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

Decreasing feature sizes combined with high mask error enhancement factors (MEEF) are rapidly causing tighter defect and CD uniformity specifications on photomasks. In general, dry etching photomasks improves feature fidelity but also tends to increase defectivity. Since the first automated mask defect inspection usually occurs after chrome etch, it is difficult to determine if a defect originated with the photoblank or during one of the mask patterning steps (write, develop, and etch). To understand and optimize the dry etch process, After Develop Inspection (ADI) has been developed to isolate the cause of photomask defects. In this study, ADI was used to inspect Cr photomasks incorporating iP3600 and ZEP7000 resists at several thicknesses. The detected defects were analyzed and compared to defects found after etch. A test mask with programmed defects was also created and tested to characterize the sensitivity of this new capability.

Paper Details

Date Published: 30 December 1999
PDF: 9 pages
Proc. SPIE 3873, 19th Annual Symposium on Photomask Technology, (30 December 1999); doi: 10.1117/12.373306
Show Author Affiliations
Franklin D. Kalk, DuPont Photomasks, Inc. (United States)
Keith J. Brankner, DuPont Photomasks, Inc. (United States)
Lori Peters, Advanced Micro Devices, Inc. (United States)
Anthony Vacca, KLA-Tencor Corp. (United States)
Scott Pomeroy, KLA-Tencor Corp. (United States)
David Emery, KLA-Tencor Corp. (United States)


Published in SPIE Proceedings Vol. 3873:
19th Annual Symposium on Photomask Technology
Frank E. Abboud; Brian J. Grenon, Editor(s)

© SPIE. Terms of Use
Back to Top