Share Email Print
cover

Proceedings Paper

GA-based PID control of the plate width in hot-plate mills
Author(s): Byungman Kim; Dae Yup Lee; Hyungsuck Cho
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

In hot plate mills the slabs from incoming reheat furnace are reduced to the desired width and thickness, being rolled out with considerable accuracy. The process of changing the plate width is controlled by a pair of edge rolls, which is called edger. The objectives of this edging process are to meet tight width tolerances of plates and to reduce the yield loss caused by trimming when irregular width is formed at the plate edge. There are several factors that result in complexity and uncertainty in width control. These include inaccurate edger set-up model, degradation of various mill equipment, variation of operation conditions, environments and variation of the dimension of incoming cast slabs. In this paper, a genetic algorithm-based PID control is proposed to ensure the control of the desired width at the exit of the mill. The approach adopted here is essentially optimization of the PID controller gains in order to minimize the error between the desired and actual slab width. Since the design parameters associated with genetic algorithm affect convergence performance, the effects of these parameters are investigated in detail. In addition, the control performance is also evaluated for various process parameters such as initial width of the incoming slab and temperature of the slab. Based on the result obtained from a series of simulations, the proposed control method is found to yield satisfactory performance for various process conditions.

Paper Details

Date Published: 24 November 1999
PDF: 11 pages
Proc. SPIE 3832, Sensors and Controls for Intelligent Machining and Manufacturing Mechatronics, (24 November 1999); doi: 10.1117/12.371176
Show Author Affiliations
Byungman Kim, Korea Advanced Institute of Science and Technology (South Korea)
Dae Yup Lee, Korea Advanced Institute of Science and Technology (South Korea)
Hyungsuck Cho, Korea Advanced Institute of Science and Technology (South Korea)


Published in SPIE Proceedings Vol. 3832:
Sensors and Controls for Intelligent Machining and Manufacturing Mechatronics
Patrick F. Muir; George K. Knopf; Patrick F. Muir; Peter E. Orban, Editor(s)

© SPIE. Terms of Use
Back to Top