Share Email Print
cover

Proceedings Paper

Problem of laser impulse microshaping quality: analysis and synthesis
Author(s): Victor A. Serebryakov; Vladimir A. Rusov; Vadim P. Veiko; B. M. Jurkevich
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

Today the laser technologies are widely used in the processing of materials, including also the technologies of the precise micromachining. UV and X-ray lasers have very good prospects in the lithography, used for fabrication of chips, while the femtosecond pulsed lasers open the new horizons for the micro- and submicroscribing. But these are the prospects. As for today state-of-the-art, contributing to the application of lasers for these purposes are the numerous advantages of the laser techniques over the traditional methods, such as wide variety of materials separated, possibility of achieving narrow cuts and practically waste-free separation, small heat-affected zone, minimal mechanical effect and minimal thermal deformations, possibility of fast and precise process switch-on and off, possibility of separation along a complex profile in two, or even three, dimensions.

Paper Details

Date Published: 20 September 1999
PDF: 9 pages
Proc. SPIE 3822, Computer-Controlled Microshaping, (20 September 1999); doi: 10.1117/12.364240
Show Author Affiliations
Victor A. Serebryakov, S.I. Vavilov State Optical Institute (Russia)
Vladimir A. Rusov, S.I. Vavilov State Optical Institute (Russia)
Vadim P. Veiko, St. Petersburg Institute of Fine Mechanics and Optics (Russia)
B. M. Jurkevich, St. Petersburg Institute of Fine Mechanics and Optics (Russia)


Published in SPIE Proceedings Vol. 3822:
Computer-Controlled Microshaping
Vadim P. Veiko; Tamas Szoerenyi, Editor(s)

© SPIE. Terms of Use
Back to Top