Share Email Print
cover

Proceedings Paper

Surface height and geometry parameters for describing shape of weld pool during pulsed GTAW
Author(s): Dongbin Zhao; Shanben Chen; Lin Wu
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

Weld penetration and fine formation are the major factors for consideration of weld bead quality. The geometry of weld pool contains abundant information about the weld penetration. The weld pool surface is depressed during full- penetration because of arc impulse, and the weld pool surface may be convex during part-penetration or welding with filler. In this paper, we present the surface height and shape parameters for describing the three dimension of weld pool. During pulsed GTAW process, the weld pool image can be obtained through visual sensing system by the illumination of arc light on weld pool. The inverted image of tungsten tip and arc shape can be seen clearly from the weld pool image. The position of inverted tungsten tip varies with the surface height according to the principle of specula reflection. The point of tungsten tip is located to calculate the surface height. The shape of weld pool has been characterized with size and shape parameters, such as pool width, length and a series of rear angles, etc. A simple nonlinear formula with only four parameters is proposed for describing the pool shape, and the regression results are shown with high accuracy. Based on the surface height and geometry parameters of weld pool, the shape of weld pool can be strictly defined, which lays the foundation for further study on process model and weld penetration control.

Paper Details

Date Published: 20 August 1999
PDF: 8 pages
Proc. SPIE 3833, Intelligent Systems in Design and Manufacturing II, (20 August 1999); doi: 10.1117/12.359509
Show Author Affiliations
Dongbin Zhao, Harbin Institute of Technology (China)
Shanben Chen, Harbin Institute of Technology (China)
Lin Wu, Harbin Institute of Technology (China)


Published in SPIE Proceedings Vol. 3833:
Intelligent Systems in Design and Manufacturing II
Bhaskaran Gopalakrishnan; San Murugesan, Editor(s)

© SPIE. Terms of Use
Back to Top