Share Email Print
cover

Proceedings Paper

Mechanical-thermal simulation of surface-micromachined polysilicon hot plates
Author(s): Mihail M. Dumitrescu; Corbel Cobianu; Dan C. Dascalu; Adrian Pascu
Format Member Price Non-Member Price
PDF $14.40 $18.00
cover GOOD NEWS! Your organization subscribes to the SPIE Digital Library. You may be able to download this paper for free. Check Access

Paper Abstract

A surface micromachined polysilicon membrane, compatible with IC technology, was technologically designed and mechanically and thermally simulated by 3D finite element 'COSMOS' program in order to investigate its capability to work as micro hot plates for gas sensing applications. The optimized lay-out of hot plate consists of a polysilicon membrane of area of 110 by 110 micrometers 2 supported by four 'poly' suspended bridges and a central 'poly' pillar (MWCP). The air gap between membrane and substrate is equal to 1 micrometers . Within this paper, the simulation results are shown as a function of input power and surface area of the membrane. At room temperature the following results were obtained. The maximum normal stress has a value of 151.12 N/m2 and is situated at a distance of 20 micrometers around the central pillar. Also, the maximum displacement has a value of 3.81 by 10-4 micrometers and it is located at about half distance between the center of the membrane and its lateral edge. At an input power of 100 mW applied to the MWCP structure, the strain-stress spatial distributions have been qualitatively preserved with respect to RT situation but all the values increased by about 1300 times. The value of this normal stress for the MWCP structure is now about 196.45728 by 103 N/m2. For an input power of 100 mW, the maximum displacements of the membrane are located in the same place as in the RT case, and their values are lower than 0.1 micrometers .

Paper Details

Date Published: 10 March 1999
PDF: 8 pages
Proc. SPIE 3680, Design, Test, and Microfabrication of MEMS and MOEMS, (10 March 1999); doi: 10.1117/12.341221
Show Author Affiliations
Mihail M. Dumitrescu, National Institute for Research and Development in Microtechnologies (Finland)
Corbel Cobianu, National Institute for Research and Development in Microtechnologies (Romania)
Dan C. Dascalu, National Institute for Research and Development in Microtechnologies (Romania)
Adrian Pascu, Politehnica Univ. Bucharest (Romania)


Published in SPIE Proceedings Vol. 3680:
Design, Test, and Microfabrication of MEMS and MOEMS
Bernard Courtois; Wolfgang Ehrfeld; Selden B. Crary; Wolfgang Ehrfeld; Hiroyuki Fujita; Jean Michel Karam; Karen W. Markus, Editor(s)

© SPIE. Terms of Use
Back to Top