Share Email Print
cover

Proceedings Paper

Characterization and control of the laser microsoldering process for solid solder deposits using pyrometry
Author(s): Hans-Joerg Pucher; Marc Fleckenstein
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

Reflow soldering using laser beam radiation is an attractive joining technique for fine-pitch components used in electronics. It allows contactless and force-free processing of all optically accessible areas with limited and easily controllable heat supply. The analysis of pyrometer signals during laser micro soldering can be seen as the basis of process control. Therefore, the timedependent courses of the thermal radiation of the joints during soldering were determined. They show characteristic arrests, turning points and changes in slope respectively. These changes permit a simplified classification of the soldering process in three phases: "reflow of the solder deposit", "wetting of the joining partners" and "cooling of the joint". In former research projects concerned with the characterization of the reflow behaviour and the wettability, only the actual solder deposit or the soldering of passive components were investigated. The tests were performed on fine-pitch structures made of FeNi42 and CuFe2P, typical materials used in electronics, and with solid solder deposits (SSD). The characteristic signal courses and the temperature of the joint were recorded with the aid of a PbSe pyrometer and with thermoelectric couples, the time of reflow was additionally determined by analyzing the structure-borne noise emission and the complete soldering process was visualized with a high-speed camera for the verification of the findings. The process windows were determined on the basis of optimum laser power and corresponding pulse duration. The use of pulse durations longer than e.g. 40 ms allowed clear recognition of characteristic features to be used as a basis of control strategies (CuFe2P, pitch: 300 rim). Very short process durations (TH < 10 ms) could also be realized with good soldering joints. However, control during this process is not possible because of the wetting process taking place with a time delay over the laser pulse. Also the process window, which lies between non-wetting and destruction of the joining partners, is very small.

Keywords: laser micro soldering, solid solder deposits (SSD), process characterization, melting process, wetting process, cooling process, pyrometry

Paper Details

Date Published: 27 August 1998
PDF: 11 pages
Proc. SPIE 3509, In-Line Characterization Techniques for Performance and Yield Enhancement in Microelectronic Manufacturing II, (27 August 1998); doi: 10.1117/12.324414
Show Author Affiliations
Hans-Joerg Pucher, Plansee TIZIT GmbH (Austria)
Marc Fleckenstein, Univ. Erlangen-Nuernburg (Germany)


Published in SPIE Proceedings Vol. 3509:
In-Line Characterization Techniques for Performance and Yield Enhancement in Microelectronic Manufacturing II
Sergio A. Ajuria; Tim Z. Hossain, Editor(s)

© SPIE. Terms of Use
Back to Top