Share Email Print
cover

Proceedings Paper

Surface chemistry of GaAs wafers and reaction with chemically amplified resists during resist processing
Author(s): Bing Lu; Olga Vladimirsky; James Welch Taylor; Niru V. Dandekar
Format Member Price Non-Member Price
PDF $14.40 $18.00
cover GOOD NEWS! Your organization subscribes to the SPIE Digital Library. You may be able to download this paper for free. Check Access

Paper Abstract

The surface preparation of wafers used with chemically- amplified resist is critical for successful resist processing. GaAs wafers provide an additional complexity because the composition of the surface can be greatly affected by the chemical treatment and subsequent resist processing conditions. In order to get consistent rust with GaAs wafers, we have found that the surface composition of the wafer has to be determined. Secondary ion mass spectrometry (SIMS) and electron spectroscopy for chemical analysis were used to determine the surface composition before and after the treatment with HCl. A non-destructive and simple method of contact angle measurement was used to provide advance warning of difficulties with adhesion between GaAs and Shipley SAL605 negative-tone chemically- amplified resist. An observed correlation between the contact angel of water suggested that, when it was in the range of 60 degrees to 75 degrees, the wafers generally showed good adhesion when using aqueous developer, Shipley MF312. From the work of direct measurement of the wafer surface before and after treatment, we have found conditions that permit patterning linewidths on the order of 0.15 micron in 0.5 micron thick resist. The effects of each of the surface treatments found to influence the adhesion will be described in terms of the chemical changes on the wafer surface and their effect on the resist chemistry.

Paper Details

Date Published: 5 June 1998
PDF: 6 pages
Proc. SPIE 3331, Emerging Lithographic Technologies II, (5 June 1998); doi: 10.1117/12.309610
Show Author Affiliations
Bing Lu, Ctr. for X-ray Lithography/Univ. of Wisconsin-Madison (United States)
Olga Vladimirsky, Ctr. for X-ray Lithography/Univ. of Wisconsin-Madison (United States)
James Welch Taylor, Ctr. for X-ray Lithography/Univ. of Wisconsin-Madison (United States)
Niru V. Dandekar, Sanders, A Lockheed Martin Co. (United States)


Published in SPIE Proceedings Vol. 3331:
Emerging Lithographic Technologies II
Yuli Vladimirsky, Editor(s)

© SPIE. Terms of Use
Back to Top