Share Email Print
cover

Proceedings Paper

Influence of processing speed on cut quality in laser beam gas cutting of copper
Author(s): Norbert Bartl; Hans Wilhelm Bergmann
Format Member Price Non-Member Price
PDF $14.40 $18.00
cover GOOD NEWS! Your organization subscribes to the SPIE Digital Library. You may be able to download this paper for free. Check Access

Paper Abstract

During the last few years technical innovations in the field of laser beam sources have led to almost a complete equalization of the process impeding properties of copper for laser beam cutting. The present work was performed to outline the potential of laser beam gas cutting of copper for generating quality cuts under practice-orientated conditions. With regard to the importance of cutting speed on both cut quality and economic efficiency of processing the focus of interest was put on the influence of cutting speed on application relevant features. For this purpose a series of speed varying cutting experiments on copper sheets of 0.5 to 15 mm thickness was carried out. The tests were arranged to two commercially available cw-CO2-laser beam cutting machines and maximum power ratings of 3 kW and 18 kW. Cutting speed exercises an influence on all features examined. The most susceptible features are deviation from right angle and height of dross. Deviation from right angle can be improved for 100% to several 100%. Dross height can be reduced for between 40 and 80%. On the other hand the features kerf width and surface roughness are less susceptible to cutting speed. For the examined range of cutting speeds and sheet thicknesses width of kerf varies between 5 and 15%, surface roughness between 10 and 30%. Sheets in the range of 1 to 10 mm thickness are possible to be cut with an accuracy better than 50 micrometers , sheets thicker than 10 mm with an accuracy of 150 to 200 micrometers . With inclination angles of 0.5 to 2 degree(s) kerfs can said to be parallel sided. For sheets of thicknesses below 1 mm roughness values of about 25 micrometers are achievable. Sheets of thicknesses of between 1 and 5 mm show roughnesses of approximately 50 micrometers . For sheets of thicknesses above 10 mm roughnesses in the region of 100 micrometers can be obtained.

Paper Details

Date Published: 18 August 1997
PDF: 9 pages
Proc. SPIE 3097, Lasers in Material Processing, (18 August 1997); doi: 10.1117/12.281134
Show Author Affiliations
Norbert Bartl, Univ. of Erlangen-Nuremberg (Germany)
Hans Wilhelm Bergmann, Univ. of Erlangen-Nuremberg (Germany)


Published in SPIE Proceedings Vol. 3097:
Lasers in Material Processing
Leo H. J. F. Beckmann, Editor(s)

© SPIE. Terms of Use
Back to Top