Share Email Print
cover

Proceedings Paper

Application of laser speckle displacement analysis to clinical dentistry
Author(s): G. K. D. Cumberpatch; J. A. A. Hood
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

Success of dental restorations is dependent on the integrity of the tooth/restoration interface. Distortion of teeth due to operative procedures has previously been measured using LVDT's and strain-gauges and has provided useful but limited information. This paper reports on the verification of a system for laser speckle photography and its use to quantitative distortions in teeth from matrix band application and the use of bonded composite resin restorations. Tightening of matrix bands around teeth results in an inward deformation of the cusps, increasing incrementally as the band is tightened. Deflections of 50 micrometer/cusp were recorded. A delayed recovery was noted consistent with the viscoelastic behavior of dentine. For bonded restorations recovery will place the adhesion interface in a state of tension when the band is released and may cause premature failure. Premolar teeth restored with bonded resin restorations exhibited inward displacement of cusps of 12 - 15 micrometer. Deformation was not within the buccal-lingual axis as suggested by prior studies. Molar teeth bonded with composite resin restoration exhibit complex and variable cusp displacement in both magnitude (0 - 30 micrometer) and direction. Complete and partial debonding could be detected. Interproximal cusp bending could be quantitated and lifting of the restoration from the cavity floor was detectable. Deformations evidenced indicate the tooth/restoration interface is in a stressed state and this may subsequently lead to failure. The technique has the potential to aid in development of restoration techniques that minimize residual stress.

Paper Details

Date Published: 20 March 1997
PDF: 6 pages
Proc. SPIE 2921, International Conference on Experimental Mechanics: Advances and Applications, (20 March 1997); doi: 10.1117/12.269799
Show Author Affiliations
G. K. D. Cumberpatch, Univ. of Otago (New Zealand)
J. A. A. Hood, Univ. of Otago (New Zealand)


Published in SPIE Proceedings Vol. 2921:
International Conference on Experimental Mechanics: Advances and Applications

© SPIE. Terms of Use
Back to Top