Share Email Print
cover

Proceedings Paper

Laser drilling in rare-earth magnets
Author(s): GuoZhong Zhang; Li Min Liu; Changjiang Li
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

A Nd/YAG pulse laser is used to drill in Sm-Co and Nd-Fe-B permanent magnetic rotor. The experimental studies and analysis on the morphology and the phase composition of the drilled rotor are described. In the center of the drilled rotor, there is a hole which diameter is equal roughly to the girdle size of the Gauss laser beam. The hole wall is rapid fused amorphous matter, which morphology and composition are obviously different from that before hole drilling. The grain in heat-affected zone fined, but the composition has not changed. The experimental results show that the reasonable selection of laser parameters according to physical properties of materials is necessary in order to improve product quality and production efficiency and that the lower laser power, the narrower pulse and the multiple- drilling and advantageous to the processing for hard-brittle materials as rare-earth magnets.

Paper Details

Date Published: 30 September 1996
PDF: 5 pages
Proc. SPIE 2888, Laser Processing of Materials and Industrial Applications, (30 September 1996); doi: 10.1117/12.253137
Show Author Affiliations
GuoZhong Zhang, Beijing Union Univ. (China)
Li Min Liu, Beijing Univ. of Chemical Technology (China)
Changjiang Li, Beijing Univ. of Chemical Technology (China)


Published in SPIE Proceedings Vol. 2888:
Laser Processing of Materials and Industrial Applications
Shu-Sen Deng; S. C. Wang, Editor(s)

© SPIE. Terms of Use
Back to Top