Share Email Print
cover

Proceedings Paper • new

Magnetic vortex state applied in magnetoresistive sensors (Conference Presentation)

Paper Abstract

Magnetoresistive sensors based on giant magnetoresistance (GMR) or tunnel magnetoresistance (TMR) play a major role towards the miniaturization in the industrial society. Typically, spin-valve-type magnetoresistive sensors are embedded in a Wheatstone bridge configuration with rectangular, meander-like or elliptically shaped thin film elements. Such elements usually switch via multi-domain, C- or S-shaped magnetization states and, therefore, often exhibit an open non-linear hysteresis curve. Linearity and hysteretic effects are key features in the improvement of such sensors. We will present a different approach by using circularly shaped elements exhibiting a different magnetization state of a magnetic vortex [1]. This is one of the fundamental magnetization ground states occurring in disk-shaped thin film elements and is characterized by minimization of the demagnetizing energy at the expense of exchange energy. Experimental data were generated on electrically contacted GMR and TMR disks which were fabricated by optical lithography. The following advantages will be discussed and compared to standard elliptical sensor elements. (a) The vortex state shows essentially no hysteresis in the minor loop. (b) Since the vortex nucleation happens prior to the zero field, the M(H=0)=0 crossing is independent of history. (c) The critical fields can be easily controlled by the element geometry. (d) The noise is low. All characteristic experimental values have been determined in dependence of free layer thickness, disk diameter and temperature. These findings are discussed in the frame of the semi-analytical rigid-vortex-model [2] and micromagnetic simulations. The financial support by the Austrian Federal Ministry of Science, Research and Economy and the Christian Doppler Research Association in Austria is gratefully acknowledged. [1] D. Suess, A. Bachleitner-Hofmann, A. Satz, H. Weitensfelder, C. Vogler, F. Bruckner, C. Abert, K. Prügl, J. Zimmer, C. Huber, S. Luber, W. Raberg, T. Schrefl, H. Brückl, „Topologically Protected Vortex Structures to Realize Low-Noise Magnetic Sensors with High Linear Range”, Nature Electronics 1, 362 (2018) [2] K. Y. Guslienko et al., “Magnetization reversal due to vortex nucleation, displacement, and annihilation in submicron ferromagnetic dot arrays”, Phys. Rev. B 65 (2001)

Paper Details

Date Published: 10 September 2019
PDF
Proc. SPIE 11090, Spintronics XII, 110903T (10 September 2019); doi: 10.1117/12.2525294
Show Author Affiliations
Hubert Brückl, Danau-Univ. Krems (Austria)
Herbert Weitensfelder, Univ. Wien (Austria)
Danau-Univ. Krems (Austria)
Armin Satz, Infineon Technologies Austria AG (Austria)
Klemens Pruegl, Infineon Technologies AG (Germany)
Sebastian Luber, Infineon Technologies AG (Germany)
Wolfgang Raberg, Infineon Technologies AG (Germany)
Juergen Zimmer, Infineon Technologies AG (Germany)
Dieter Suess, Univ. Wien (Austria)


Published in SPIE Proceedings Vol. 11090:
Spintronics XII
Henri-Jean M. Drouhin; Jean-Eric Wegrowe; Manijeh Razeghi, Editor(s)

© SPIE. Terms of Use
Back to Top