Share Email Print
cover

Proceedings Paper

Fabrication of a high-fill-factor microlens array using different thermal reflow process
Author(s): Biao Yang; Jinyun Zhou
Format Member Price Non-Member Price
PDF $17.00 $21.00

Paper Abstract

Thermal reflow is widely used in the fabrication of microlenses as a simple and low-cost process, which includes the direct contact heating and the upside-down reflow. To compare the difference in the shapes of the microlenses obtained by these two approaches, the cylindrical microstructure arrays obtained rapidly via DMD-based lithography system were used for different thermal reflow processes, and subsequently, two types of high-fill-factor microlens arrays (MLAs) were fabricated and measured in the experiment. Results indicate that the MLAs obtained by these two kinds of thermal reflow have different surface profiles, while these MLAs are good in surface quality because the profile curves of each microlens are very similar and continuous. The comparison results provided in this paper can be used as a reference for selecting the appropriate thermal reflow process for fabrication of other microlenses.

Paper Details

Date Published: 24 January 2019
PDF: 5 pages
Proc. SPIE 11052, Third International Conference on Photonics and Optical Engineering, 110521J (24 January 2019); doi: 10.1117/12.2522470
Show Author Affiliations
Biao Yang, Guangdong Univ. of Technology (China)
Jinyun Zhou, Guangdong Univ. of Technology (China)


Published in SPIE Proceedings Vol. 11052:
Third International Conference on Photonics and Optical Engineering
Ailing Tian, Editor(s)

© SPIE. Terms of Use
Back to Top