Share Email Print
cover

Proceedings Paper • new

Monte Carlo simulations of X-ray-generated electron cascades in ruthenium (Conference Presentation)
cover GOOD NEWS! Your organization subscribes to the SPIE Digital Library. You may be able to download this paper for free. Check Access

Paper Abstract

Modern free-electron lasers produce femtosecond X-ray pulses sufficiently intense to induce modifications of material properties. Energetic photoelectrons created upon the X-ray absorption and Auger electrons emitted after relaxation of core-hole states trigger secondary electron cascades, which increase the transient electron density. In this talk, we present and apply the XCASCADE(3D) code [1], based on classical event-by-event individual-particle Monte-Carlo approach, which is valid for relatively low absorbed fluences. The code takes into account photoabsorption, electron impact ionization, electron elastic scattering, and Auger decays of core holes. It uses atomistic cross sections and atomistic ionization potentials. Such approximation is justified for high-energy X-ray absorption and for high-energy electron-atom collisions, since they both excite electrons from the deeply lying core levels. At the same time, it makes the approach very efficient and flexible, since the corresponding cross sections can be found in the literature for many elements. In this approximation, one can treat any practical material assuming that the total cross section is the sum of cross sections for each individual atom. Elastic and inelastic anisotropic scatterings of photo- and secondary electrons on atoms are taken into account. The validity of the model is confirmed by comparing the calculated electron ranges with published data for silicon and gold. We apply the code to study the consequences of the electron cascading in ruthenium (Ru). Ru, which is a promising material for coating of X-ray mirrors [2], is simulated at different incoming photon energies, from extreme ultraviolet (XUV) to hard x-ray, in a grazing incidence geometry. The generated data then serve as an input to Two-Temperature Model, enabling analysis of the temperature evolution and damage thresholds [2]. According to the simulations, much larger electron ranges for hard x-rays case result in spread of absorbed laser energy into a larger volume compared to the XUV case and, consequently, into smaller temperature gradients. The latter is the source of thermo-induced stresses that eventually lead to material damage. As a consequence of the electron transport, one should expect higher damage thresholds with increasing energy of incident photons, even for the same photon penetration depth, which can be achieved by adjusting the incident angle. [1] V. Lipp, N. Medvedev, B. Ziaja, Proc. SPIE 10236, 102360H (2017). [2] Igor Milov, Igor A. Makhotkin, Ryszard Sobierajski, Nikita Medvedev, Vladimir Lipp et al., Opt. Express 26, 19665-19685 (2018).

Paper Details

Date Published: 14 May 2019
PDF
Proc. SPIE 11035, Optics Damage and Materials Processing by EUV/X-ray Radiation VII, 110350T (14 May 2019); doi: 10.1117/12.2520640
Show Author Affiliations
Vladimir P. Lipp, Ctr. for Free-Electron Laser Science, Deutsches Elektronen-Synchrotron (Germany)
Igor Milov, Univ. of Twente (Netherlands)
Nikita Medvedev, Institute of Physics of the CAS, v.v.i. (Czech Republic)
Institute of Plasma Physics of the ASCR, v.v.i. (Czech Republic)
Beata Ziaja, Center for Free-Electron Laser Science, Deutsches Elektronen-Synchrotron (Germany)
Institute of Nuclear Physics, Polish Academy of Sciences (Poland)


Published in SPIE Proceedings Vol. 11035:
Optics Damage and Materials Processing by EUV/X-ray Radiation VII
Libor Juha; Saša Bajt; Stéphane Guizard, Editor(s)

© SPIE. Terms of Use
Back to Top