Share Email Print
cover

Proceedings Paper

Increasing critcal depth of cut in ductile mode machining of tungsten carbide by process parameter controlling
Author(s): M. Doetz; O. Dambon; F. Klocke; J. Lee; O. Fähnle; E. Langenbach
Format Member Price Non-Member Price
PDF $14.40 $18.00
cover GOOD NEWS! Your organization subscribes to the SPIE Digital Library. You may be able to download this paper for free. Check Access

Paper Abstract

Ductile mode machining is usually applied for the optical finishing operation of e.g. tungsten carbide molds. One request for this mode is not to exceed the critical depth of cut hcu,crit characterized by the transition point from ductile to brittle material removal.

Based on experimental investigations a formula for the critical depth of cut, relating the material specific properties Young’s-Modulus E, material hardness H and fracture toughness KC was developed by Bifano et. all [1]. Even when the influence of cutting conditions, like tool or process characteristics, are neglected the formula is widely used for setting up UPM machines ever since. However, previous investigations have shown that hcu,crit strongly depends on coolant fluid characteristic as well as on the compressive stress applied into the cutting zone by the use of tools with e.g. negative rank angles [2].

In this paper, we report on a ductile process analysis applying a recently developed method for process optimization in optics fabrication [3]. Following that trail, critical process parameters have been identified and their influences on the critical depth of cut hcu,crit have been tested experimentally in fundamental ruling tests.

Among others, following parameters were identified and tested: (a) characteristics of the coolant used, (b) the pH value of the coolant, (c) the tool specifications of the applied diamond and (d) whether ultrasonic assistance (US) is being switched on or off. Depending on the applied set of process parameters and for the experimental data collected, maximum ductile mode material removal rates could be achieved with dcmax = 1600 nm.

That way, a new formula was developed, which allows the prediction of the critical depth of cut depending on critical process parameters while machining binderless nanocrystalline tungsten carbide. The formula was set up based on experimental results and is one step towards extending Bifanos formula taking the influences of critical process parameters into account.

Paper Details

Date Published: 7 August 2018
PDF: 7 pages
Proc. SPIE 10829, Fifth European Seminar on Precision Optics Manufacturing, 108290J (7 August 2018); doi: 10.1117/12.2318709
Show Author Affiliations
M. Doetz, Fraunhofer Institute for Production Technology IPT (Germany)
O. Dambon, Fraunhofer Institute for Production Technology IPT (Germany)
F. Klocke, Fraunhofer Institute for Production Technology IPT (Germany)
J. Lee, Fraunhofer Institute for Production Technology IPT (Germany)
O. Fähnle, FISBA AG (Switzerland)
E. Langenbach, FISBA AG (Switzerland)


Published in SPIE Proceedings Vol. 10829:
Fifth European Seminar on Precision Optics Manufacturing
Rolf Rascher; Christian Schopf, Editor(s)

© SPIE. Terms of Use
Back to Top