Share Email Print
cover

Proceedings Paper • Open Access

Development of an EMCCD for lidar applications
Author(s): B. De Monte; R. T. Bell

Paper Abstract

A novel detector, incorporating e2v’s L3 CCD (L3Vision™) [1] technology for use in LIDAR (Light Detection And Ranging) applications has been designed, manufactured and characterised. The most critical performance aspect was the requirement to collect charge from a 120μm square detection area for a 667ns temporal sampling window, with low crosstalk between successive samples, followed by signal readout with sub-electron effective noise. Additional requirements included low dark signal, high quantum efficiency at the 355nm laser wavelength and the ability to handle bright laser echoes, without corruption of the much fainter useful signals.

The detector architecture used high speed charge binning to combine signal from each sampling window into a single charge packet. This was then passed through a multiplication register (Electron Multiplying Charge Coupled Device) operating with a typical gain of 100X to a conventional charge detection circuit. The detector achieved a typical quantum efficiency of 80% and a total noise in darkness of < 0.5 electrons rms. Development of the detector was supported by ESA (European Space Agency).

Paper Details

Date Published: 20 November 2017
PDF: 7 pages
Proc. SPIE 10565, International Conference on Space Optics — ICSO 2010, 1056502 (20 November 2017); doi: 10.1117/12.2309150
Show Author Affiliations
B. De Monte, e2v Grenoble (France)
R. T. Bell, e2v Technologies (United Kingdom)


Published in SPIE Proceedings Vol. 10565:
International Conference on Space Optics — ICSO 2010
Errico Armandillo; Bruno Cugny; Nikos Karafolas, Editor(s)

© SPIE. Terms of Use
Back to Top