Share Email Print
cover

Proceedings Paper • Open Access • new

Selection of fiber-optical components for temperature measurement for satellite applications
Author(s): P. Putzer; N. Kuhenuri Chami; A. W. Koch; A. Hurni; M. Roner; J. Obermaier; N. M. K. Lemke

Paper Abstract

The Hybrid Sensor Bus (HSB) is a modular system for housekeeping measurements for space applications. The focus here is the fiber-optical module and the used fiber-Bragg gratings (FBGs) for temperature measurements at up to 100 measuring points. The fiber-optial module uses a tunable diode laser to scan through the wavelength spectrum and a passive optical network for reading back the reflections from the FBG sensors. The sensors are based on FBGs which show a temperature dependent shift in wavelength, allowing a high accuracy of measurement.

The temperature at each sensor is derivated from the sensors Bragg wavelength shift by evaluating the measured spectrum with an FBG peak detection algorithm and by computing the corresponding temperature difference with regard to the calibration value. It is crucial to eliminate unwanted influence on the measurement accuracy through FBG wavelength shifts caused by other reasons than the temperature change. The paper presents gamma radiation test results up to 25 Mrad for standard UV-written FBGs in a bare fiber and in a mechanically housed version. This high total ionizing dose (TID) load comes from a possible location of the fiber outside the satellite's housing, like e.g. on the panels or directly embedded into the satellites structure. Due to the high shift in wavelength of the standard written gratings also the femto-second infrared (fs- IR) writing technique is investigated in more detail.

Special focus is given to the deployed fibers for the external sensor network. These fibers have to be mechanically robust and the radiation induced attenuation must be low in order not to influence the system's performance. For this reason different fiber types have been considered and tested to high dose gamma radiation. Dedicated tests proved the absence of enhanced low dose rate sensitivity (ELDRS). Once the fiber has been finally selected, the fs-IR grating will be written to these fibers and the FBGs will be tested in order to investigate the radiation induced wavelength shift.

The FBGs react on temperature and strain change, so a decoupling of both physical effects must be assured to allow a precise measurement over large temperature ranges and corresponding potential mechanical stress, passed from the structure to the sensor. This potential source of error is addressed with the design of a strain-decoupled temperature transducer to which the FBGs are glued. The design of the transducer and measurement results of a bending test are provided within this paper.

An outlook of the usage of fiber-optical sensing in space applications will be given. One promising field of application are the so called photonically-wired spacecraft panels, where optical fibers with integrated FBGs are being integrated in panels for temperature measurements and high-speed data transfer at the same time.

Paper Details

Date Published: 17 November 2017
PDF: 9 pages
Proc. SPIE 10563, International Conference on Space Optics — ICSO 2014, 105631C (17 November 2017); doi: 10.1117/12.2304276
Show Author Affiliations
P. Putzer, Technische Univ. München (Germany)
N. Kuhenuri Chami, Technische Univ. München (Germany)
A. W. Koch, Technische Univ. München (Germany)
A. Hurni, OHB System A.G. (Germany)
M. Roner, OHB System A.G. (Germany)
J. Obermaier, OHB System A.G. (Germany)
N. M. K. Lemke, OHB System A.G. (Germany)


Published in SPIE Proceedings Vol. 10563:
International Conference on Space Optics — ICSO 2014
Zoran Sodnik; Bruno Cugny; Nikos Karafolas, Editor(s)

© SPIE. Terms of Use
Back to Top