Share Email Print
cover

Proceedings Paper • new

Microfabrication of PDMS structures based on wave optics using EUV radiations from laser-produced plasma (Conference Presentation)
Author(s): Tetsuya Makimura; Hikari Urai; Eriko Kira; Hiroyuki Niino
cover GOOD NEWS! Your organization subscribes to the SPIE Digital Library. You may be able to download this paper for free. Check Access

Paper Abstract

Polydimethylsiloxane (PDMS) is a material used for bio-chips and micro total analysis systems / lab-on-chips. For further development, it is inevitable to develop a technique to fabricate precise structures on micrometer scale at high aspect ratio. In the previous works, we reported a technique for high-quality micromachining of PDMS sheets, by means of ablating the PDMS sheets using EUV radiations around 10 nm from laser-produced plasma. In the present work, we have investigated fabricated structures based on wave optics, for fabricating designed strutures at submicrometer precision at high aspect ratio up to 10. We experimentally found that a deep hole with a diamter of 100 nm is formed at the center of flat ablated region after EUV irradiation of a PDMS sheet through a circular aperture with a diamter of two micrometers in a contact mask. In the case of EUV irradiation through square apertures, the deep hole was not found on a PDMS sheet, while narrow dip is formed at the edge of the ablated region. We numerically calculated propagations of EUV plane wave light in PDMS sheets. After traveling one micrometer from a circular aperture, an intense peak appears at the center of the beam, which is caused by diffraction. For the square apertures, the enhancement does not occur, while intense profile near the edge is formed due to the Fresnel diffraction. Interestingly, at 100 micormeters from the aperture, the Frenel peaks are superposed at the center, resulting in a narrow and intense beam.

Paper Details

Date Published: 14 March 2018
PDF
Proc. SPIE 10519, Laser Applications in Microelectronic and Optoelectronic Manufacturing (LAMOM) XXIII, 105190X (14 March 2018); doi: 10.1117/12.2289413
Show Author Affiliations
Tetsuya Makimura, Univ. of Tsukuba (Japan)
Hikari Urai, Univ. of Tsukuba (Japan)
Eriko Kira, Univ. of Tsukuba (Japan)
Hiroyuki Niino, National Institute of Advanced Industrial Science and Technology (Japan)


Published in SPIE Proceedings Vol. 10519:
Laser Applications in Microelectronic and Optoelectronic Manufacturing (LAMOM) XXIII
Beat Neuenschwander; Costas P. Grigoropoulos; Tetsuya Makimura; Gediminas Račiukaitis, Editor(s)

© SPIE. Terms of Use
Back to Top