Share Email Print
cover

Proceedings Paper • new

Manufacturing of three dimensional silicate moldings by selective laser beam sintering
Author(s): A.-M. Schwager; J. Bliedtner; A. Bruder; K. Götze
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

The efficient production of complex glass components is often not possible with classical manufacturing methods. In order to obtain glazed three-dimensional quartz glass moldings, the alternative method of selective laser beam sintering is investigated.

Using synthetic and natural silica powders enables an additive production by high-temperature selective laser sintering (HT-SLS). Particle-diameters in the range of 19...78 μm and spheroidal and vitrified particle-shapes allow to manufacture green bodies. For this purpose, an experimental set up as well as material-specific scan and parameter concepts are developed. Component densities of ρR = 65 % and surface roughness of Ra = 32.21 μm are achieved. Subsequently a glassy, opaque molded body is produced by temperature pressure sintering. The component density increases to ρR = 96 % with a shrinkage of 16%. In order to use the glazed molded body as glass fiber preform, polishing of the shell surface is necessary. Surface roughness of Ra = 10.4 nm can be realized by laser beam polishing.

Basically, HT-SLS is an alternative method to the classical isostatic pressing of glass powder. In particular, an increase in efficiency with regard to the producible component geometry of the green bodies can be achieved.

Paper Details

Date Published: 16 October 2017
PDF: 8 pages
Proc. SPIE 10448, Optifab 2017, 1044824 (16 October 2017); doi: 10.1117/12.2279691
Show Author Affiliations
A.-M. Schwager, Ernst-Abbe-Univ. of Applied Sciences (Germany)
J. Bliedtner, Ernst-Abbe-Univ. of Applied Sciences (Germany)
A. Bruder, Ernst-Abbe-Univ. of Applied Sciences (Germany)
K. Götze, Ernst-Abbe-Univ. of Applied Sciences (Germany)


Published in SPIE Proceedings Vol. 10448:
Optifab 2017
Julie L. Bentley; Sebastian Stoebenau, Editor(s)

© SPIE. Terms of Use
Back to Top