Share Email Print
cover

Proceedings Paper

Application of boron-doped diamond film and ZnO layer in the Fabry-Pérot interferometer
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

In this article there have been presented the use of boron-doped diamond films for sensor applications. The low-finesse Fabry-Pérot interferometer working in the reflective mode has been implemented. Two kinds of reflective layers have been elaborated: boron-doped diamond thin films and zinc-oxide (ZnO) layer. Thin ZnO layers were deposited by Atomic Layer Deposition (ALD) on the face of a standard telecommunication single-mode optical fiber (SMF-28). Boron-doped diamond films were deposited using Microwave Plasma Enhanced Chemical Vapour Deposition (μPE CVD) system. Measurements were performed for various lengths of the air cavity in the reflective mode. The cavity length was varied from 0 μm to 600 μm in increments of 50 μm. Representative measured spectra obtained with a cavity length of 100 μm. The preliminary investigation of elaborated the low-coherence interferometers Fabry-Pérot have shown their ability for their application in sensors applications.

Paper Details

Date Published: 2 September 2016
PDF: 6 pages
Proc. SPIE 10034, 11th Conference on Integrated Optics: Sensors, Sensing Structures, and Methods, 1003408 (2 September 2016); doi: 10.1117/12.2243999
Show Author Affiliations
D. Majchrowicz, Gdansk Univ. of Technology (Poland)
W. Den, Gdansk Univ. of Technology (Poland)
M. Jędrzejewska-Szczerska, Gdansk Univ. of Technology (Poland)


Published in SPIE Proceedings Vol. 10034:
11th Conference on Integrated Optics: Sensors, Sensing Structures, and Methods
Tadeusz Pustelny; Przemyslaw Struk; Pawel Mergo; Jacek Wojtas, Editor(s)

© SPIE. Terms of Use
Back to Top