Share Email Print
cover

Proceedings Paper

Synchronous scan-projection lithography for fabricating cylindrical micro-parts
Author(s): Kaiki Ito; Yuta Suzuki; Toshiyuki Horiuchi
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

Lithographical patterning on the surface of a thin pipe is required for fabricating three-dimensional micro-parts. For this reason, a new exposure system for printing patterns on a cylindrical pipe by synchronous scan-projection exposure was developed. Using the exposure system, resist patterns with a width of 100 μm were printed on a surface of stainless-steel pipe with a diameter of 2 mm. The exposure time was 30 s. Printed resist pattern widths were measured in the axial and circumferential directions. As a result, pattern widths were almost uniform in both axial and circumferential directions. Judging from the experimental results, it was clarified that the patterning technology had a potential to be applied to fabrications of bio-medical devices and micro-parts.

Paper Details

Date Published: 10 May 2016
PDF: 6 pages
Proc. SPIE 9984, Photomask Japan 2016: XXIII Symposium on Photomask and Next-Generation Lithography Mask Technology, 99840I (10 May 2016); doi: 10.1117/12.2240273
Show Author Affiliations
Kaiki Ito, Tokyo Denki Univ. (Japan)
Yuta Suzuki, Tokyo Denki Univ. (Japan)
Toshiyuki Horiuchi, Tokyo Denki Univ. (Japan)


Published in SPIE Proceedings Vol. 9984:
Photomask Japan 2016: XXIII Symposium on Photomask and Next-Generation Lithography Mask Technology
Nobuyuki Yoshioka, Editor(s)

© SPIE. Terms of Use
Back to Top