Share Email Print
cover

Proceedings Paper

Optimization of polyetherimide processing parameters for optical interconnect applications
Author(s): Wei Zhao; Peter Johnson; Christopher Wall
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

ULTEM® polyetherimide (PEI) resins have been used in opto-electronic markets since the optical properties of these materials enable the design of critical components under tight tolerances. PEI resins are the material of choice for injection molded integrated lens applications due to good dimensional stability, near infrared (IR) optical transparency, low moisture uptake and high heat performance. In most applications, parts must be produced consistently with minimal deviations to insure compatibility throughout the lifetime of the part. With the large number of lenses needed for this market, injection molding has been optimized to maximize the production rate. These optimized parameters for high throughput may or may not translate to an optimized optical performance.
In this paper, we evaluate and optimize PEI injection molding processes with a focus on optical property performance. A commonly used commercial grade was studied to determine factors and conditions which contribute to optical transparency, color, and birefringence. Melt temperature, mold temperature, injection speed and cycle time were varied to develop optimization trials and evaluate optical properties. These parameters could be optimized to reduce in-plane birefringence from 0.0148 to 0.0006 in this study. In addition, we have studied an optically smooth, sub-10nm roughness mold to re-evaluate material properties with minimal influence from mold quality and further refine resin and process effects for the best optical performance.

Paper Details

Date Published: 12 October 2015
PDF: 8 pages
Proc. SPIE 9633, Optifab 2015, 96332K (12 October 2015); doi: 10.1117/12.2202829
Show Author Affiliations
Wei Zhao, SABIC Innovative Plastics (United States)
Peter Johnson, SABIC Innovative Plastics (United States)
Christopher Wall, SABIC Innovative Plastics (United States)


Published in SPIE Proceedings Vol. 9633:
Optifab 2015
Julie L. Bentley; Sebastian Stoebenau, Editor(s)

© SPIE. Terms of Use
Back to Top