Share Email Print
cover

Proceedings Paper

Using electric field manipulation to fabricate nanoscale fibers on large areas: a path to electronic and photonic devices
Author(s): Jack L. Skinner; Jessica M. Andriolo; Josh D. Beisel; Brandon M. Ross; Lance M. Purkett; John P. Murphy; Jerry Kyeremateng; Marvin J. Franson; Emily A. Kooistra-Manning; Bryce E. Hill; Bryan R. Loyola
Format Member Price Non-Member Price
PDF $14.40 $18.00
cover GOOD NEWS! Your organization subscribes to the SPIE Digital Library. You may be able to download this paper for free. Check Access

Paper Abstract

Traditional fabrication methods for the integrated circuit (IC) and the microelectromechanical systems (MEMS) industries have been developed primarily for two-dimensional fabrication on planar surfaces. More recently, commercial electronics are expeditiously emerging with non-planar displays and rapid prototype machines can be purchased for the price of a modern laptop. While electrospinning (ES) has been in existence for over 100 years, this fabrication method has not been adequately developed for commercial fabrication of electronics or the rapid prototyping industries. ES provides many benefits as a fabrication method including tunability of fiber size and affordable hardware. To realize the full potential of ES as a commonplace fabrication method for modern devices, precise control, real-time fiber morphology monitoring, and the creation of a comprehensive databank of accurate models for prediction is essential. The aim of this research is to accomplish these goals through several avenues. To improve fiber deposition control, both passive and active methods are employed to modify electric field lines during the ES process. COMSOL models have been developed to meticulously mimic experimental results for predictive planning, and an in situ laser diagnostic tool was developed to measure real-time fiber morphology during electrospinning. Further, post-processing data was generated through the use of two-dimensional fast Fourier transform (2D-FFT) to monitor alignment, and four-point conductivity measurements were taken via four independently-positioned micromanipulator probes. This article describes the devices developed to date, the a priori modeling approach taken, and resultant capabilities which complement ES as an attractive fabrication method for the electronic and photonic industry.

Paper Details

Date Published: 26 August 2015
PDF: 15 pages
Proc. SPIE 9553, Low-Dimensional Materials and Devices, 955302 (26 August 2015); doi: 10.1117/12.2192146
Show Author Affiliations
Jack L. Skinner, Montana Tech (United States)
Jessica M. Andriolo, Montana Tech (United States)
Univ. of Montana (United States)
Josh D. Beisel, Montana Tech (United States)
Brandon M. Ross, Montana Tech (United States)
Lance M. Purkett, Montana Tech (United States)
John P. Murphy, Montana Tech (United States)
Jerry Kyeremateng, Montana Tech (United States)
Marvin J. Franson, Montana Tech (United States)
Emily A. Kooistra-Manning, Montana Tech (United States)
Bryce E. Hill, Montana Tech (United States)
Bryan R. Loyola, Sandia National Labs. (United States)


Published in SPIE Proceedings Vol. 9553:
Low-Dimensional Materials and Devices
Nobuhiko P. Kobayashi; A. Alec Talin; M. Saif Islam; Albert V. Davydov, Editor(s)

© SPIE. Terms of Use
Back to Top