Share Email Print
cover

Proceedings Paper

Transmission of red-laser radiation by using Bragg fibers with air cores
Author(s): Vlastimil Matějec; Ondřej Podrazký; Ivan Kašík; Milan Frank; Michal Jelínek; Václav Kubeček
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

This paper presents experimental results on transmission characteristics of a Bragg fiber with an air core at a wavelength of 632 nm. The results are compared with those recently reported for the same fiber but at a wavelength of 1064 nm. The cladding of the fiber consists of three pairs of Bragg layers. Each pair is composed of one layer with a high and one layer with a low refractive index. A diameter of the air core is of about 50 μm. A theoretical modelling of Bragg fibers was carried out from which band gap characteristics of the fiber cladding were determined for the refractive-index contrast of the high- and low-index layers on a level of 0.03 and wavelength of 632 nm and 1064 nm.

Preforms of the Bragg fiber in the form of tubes were prepared by the MCVD method. Germanium dioxide and phosphorous pentoxide were used as silica dopants for the high-index layers. The low-index layers were fabricated of silica slightly doped with phosphorous pentoxide. The last layer applied was the high-index one. Bragg fibers were drawn from the tubes under controlled temperatures around 2000 °C in order to obtain the fibers with designed dimensions of Bragg claddings and air cores. Results of characterization of prepared fibers with optical microscopy are presented in the paper. The transmittance and attenuation of the fibers at 632 nm were measured with a continuous-wave He-Ne laser as a light source. Spatial distributions of output beams from the fibers were also determined.

Paper Details

Date Published: 7 May 2015
PDF: 7 pages
Proc. SPIE 9507, Micro-structured and Specialty Optical Fibres IV, 95070Q (7 May 2015); doi: 10.1117/12.2181971
Show Author Affiliations
Vlastimil Matějec, Institute of Photonics and Electronics of the ASCR, v.v.i. (Czech Republic)
Ondřej Podrazký, Institute of Photonics and Electronics of the ASCR, v.v.i. (Czech Republic)
Ivan Kašík, Institute of Photonics and Electronics of the ASCR, v.v.i. (Czech Republic)
Milan Frank, Czech Technical Univ. in Prague (Czech Republic)
Michal Jelínek, Czech Technical Univ. in Prague (Czech Republic)
Václav Kubeček, Czech Technical Univ. in Prague (Czech Republic)


Published in SPIE Proceedings Vol. 9507:
Micro-structured and Specialty Optical Fibres IV
Kyriacos Kalli; Jiri Kanka; Alexis Mendez, Editor(s)

© SPIE. Terms of Use
Back to Top