Share Email Print
cover

Proceedings Paper

Behavior of various cracks in the machining of glass
Author(s): Junji Shibata
Format Member Price Non-Member Price
PDF $14.40 $18.00
cover GOOD NEWS! Your organization subscribes to the SPIE Digital Library. You may be able to download this paper for free. Check Access

Paper Abstract

Today, high quality free-from-crack surfaces of brittle materials are expected to be machined by ductile mode chip formation. Firstly, abrasions and cracks formed on or beneath the machined surface were observed through turning tests with diamond cutting tools and it was discussed that the crack-free machining of glass would be possible. Secondly, the turning tests of glass with single crystal diamond conical indenters, tip radius of which are 5, 10 and 100 micrometers respectively, were performed for the purpose of investigating the criteria for crack- free chip formation, especially paying attention to the effect of indenter's tip radius. As a result, some crack-free grooves formed on the glass surface were observed, and it was concluded that one of the most important factors for ductile mode chip formation is the radius of tip curvature and suppression of a median crack.

Paper Details

Date Published: 2 August 1995
PDF: 9 pages
Proc. SPIE 2576, International Conference on Optical Fabrication and Testing, (2 August 1995); doi: 10.1117/12.215624
Show Author Affiliations
Junji Shibata, Shibaura Institute of Technology (Japan)


Published in SPIE Proceedings Vol. 2576:
International Conference on Optical Fabrication and Testing
Toshio Kasai, Editor(s)

© SPIE. Terms of Use
Back to Top