Share Email Print
cover

Proceedings Paper

Evaluation of shifter edge shape on attenuated phase-shifting mask
Author(s): Taro Saito; Hideyuki Jinbo; K. Yano; Seki Suzuki; Yoshio Tanaka
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

The influence of edge taper angle and edge roughness on transferred wafer image was investigated by computer simulation for sub-half-micron space and hole patterns on the wafer. The exposure latitude for a 0.3- micrometers space pattern on the wafer is almost unchanged for angles exceeding 60 degrees. The exposure latitude for 0.3-, 0.35-, and 0.4- micrometers hole patterns remains almost unchanged unless the edge roughness exceeds 0.04 micrometers . However, when shifter thickness on the pattern edge decreases 50%, a particularly bad case, and edge roughness of 0.01 micrometers results in 25% degradation of exposure latitude. Taking simulation results into consideration, we optimized the mask manufacturing process using wet etching for CrO-based phase shifters and obtained an edge roughness of approximately 0.01 micrometers and an edge taper angle greater than 60 degrees. Experiment showed that wet-etched mask performance is equivalent to that of the dry-etched mask.

Paper Details

Date Published: 3 July 1995
PDF: 8 pages
Proc. SPIE 2512, Photomask and X-Ray Mask Technology II, (3 July 1995); doi: 10.1117/12.212802
Show Author Affiliations
Taro Saito, Oki Electric Industry Co., Ltd. (Japan)
Hideyuki Jinbo, Oki Electric Industry Co., Ltd. (Japan)
K. Yano, Oki Electric Industry Co., Ltd. (Japan)
Seki Suzuki, Oki Electric Industry Co., Ltd. (Japan)
Yoshio Tanaka, Oki Electric Industry Co., Ltd. (Japan)


Published in SPIE Proceedings Vol. 2512:
Photomask and X-Ray Mask Technology II
Hideo Yoshihara, Editor(s)

© SPIE. Terms of Use
Back to Top