Share Email Print

Proceedings Paper

Metal deep engraving with high average power femtosecond lasers
Author(s): M. Faucon; G. Mincuzzi; F. Morin; C. Hönninger; E. Mottay; R. Kling
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

Deep engraving of 3D textures is a very demanding process for the creation of master tool e. g molds, forming tools or coining dies. As these masters are uses for reproduction of 3D patterns the materials for the tools are typically hard and brittle and thus difficult to machine. The new generation of industrial femtosecond lasers provides both high accuracy engraving results and high ablation rates at the same time. Operation at pulse energies of typically 40 μJ and repetition rates in the Mhz range the detrimental effect of heat accumulation has to be avoided. Therefore high scanning speeds are required to reduce the pulse overlap below 90%. As a consequence scan speeds in the range of 25-50 m/s a needed, which is beyond the capability of galvo scanners. In this paper we present results using a combination of a polygon scanner with a high average power femtosecond laser and compare this to results with conventional scanners. The effects of pulse energy and scan speed of the head on geometrical accuracy are discussed. The quality of the obtained structures is analyzed by means of 3D surface metrology microscope as well as SEM images.

Paper Details

Date Published: 12 March 2015
PDF: 7 pages
Proc. SPIE 9351, Laser-based Micro- and Nanoprocessing IX, 93510Q (12 March 2015); doi: 10.1117/12.2078915
Show Author Affiliations
M. Faucon, ALPhANOV (France)
G. Mincuzzi, ALPhANOV (France)
F. Morin, Amplitude Systèmes (France)
C. Hönninger, Amplitude Systèmes (France)
E. Mottay, Amplitude Systèmes (France)
R. Kling, ALPhANOV (France)

Published in SPIE Proceedings Vol. 9351:
Laser-based Micro- and Nanoprocessing IX
Udo Klotzbach; Kunihiko Washio; Craig B. Arnold, Editor(s)

© SPIE. Terms of Use
Back to Top