Share Email Print
cover

Proceedings Paper

2 μm and mid-IR fiber-laser-based sources for OCM
Author(s): C. Kieleck; A. Berrou; C. Kneis; B. Donelan; M. Eichhorn
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

This paper describes new laser sources and non linear conversion setups for 2 μm and mid-IR generation based on fiber technologies developed at ISL. Especially for jamming heat-seeking missiles, these novel designs allow to propose future compact, efficient and integrable laser systems. The specialty of the ISL technology lies in the use of single 2 μm fiber laser oscillators, which deliver the full output peak power to pump optical parametric oscillators or nonlinear fibers. No multi-stage amplifiers at 2 μm or 1.55 μm are necessary to efficiently pump non linear converters to obtained useful energies in the mid-infrared spectral range. This technology leads to efficient, simple and promising setups to be implemented in flying platforms. The best results achieved in continuous-wave (CW), Q-switched (QS) and mode-locked (ML) regimes with fiber lasers based on Tm3+-doped and Tm3+,Ho3+-codoped fibers are presented. Up to 70 W of average power was achieved around 2 μm with a Tm3+-doped fiber in CW regime. In ML regimes, at a repetition rate of 66 MHz, 50 W of average power was reached. In QS regime, up to 32 W of average power was generated around 2 μm with a polarization maintaining Tm3+-doped fiber at a repetition rate of 40 kHz. With a Tm3+,Ho3+-codoped fiber, up to 25 W of average power was obtained around 2070 nm in Q-switched regime. For example at 50 kHz, the pulse duration was around 50 ns at the maximum output power. The M2 was estimated to be less than 1.2. The emission from QS fiber lasers was used to directly pump OP-GaAs and ZGP OPOs. For example, in band II, up to 6.5 W of averaged power was recently obtained from a ZGP OPO pumped by a Tm3+-doped fiber laser. At 40 kHz repetition rate, the pulse duration was around 65 ns at the maximum output power. For 3 W of averaged output power, the M2 of the signal beam was estimated to be less than 2.1 and less than 2.4 for the idler beam. Using a mode-locked Tm3+-doped fiber laser to pump a ZBLAN fiber at an injection efficiency of ~60%, an overall supercontinuum power of up to 2.2 W from a pump power of 5.4 W was achieved. The power above 2650 nm was 0.7 W.

Paper Details

Date Published: 7 October 2014
PDF: 12 pages
Proc. SPIE 9251, Technologies for Optical Countermeasures XI; and High-Power Lasers 2014: Technology and Systems, 92510C (7 October 2014); doi: 10.1117/12.2070355
Show Author Affiliations
C. Kieleck, Institut Franco-Allemand de Recherches de Saint-Louis (France)
A. Berrou, Institut Franco-Allemand de Recherches de Saint-Louis (France)
C. Kneis, Institut Franco-Allemand de Recherches de Saint-Louis (France)
B. Donelan, Institut Franco-Allemand de Recherches de Saint-Louis (France)
M. Eichhorn, Institut Franco-Allemand de Recherches de Saint-Louis (France)


Published in SPIE Proceedings Vol. 9251:
Technologies for Optical Countermeasures XI; and High-Power Lasers 2014: Technology and Systems
David H. Titterton; Willy L. Bohn; Harro Ackermann; Mark A. Richardson; Robert J. Grasso, Editor(s)

© SPIE. Terms of Use
Back to Top