Share Email Print
cover

Proceedings Paper

In-process clad quality monitoring using optical method
Author(s): L. Li; William M. Steen
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

Although laser cladding has been accepted by industry as one of the methods for the improvement of material surface properties, it is always difficult to produce consistent products over long periods. The reason for these could be the instability of laser parameters, powder feeding parameters (when powder feeder is used) and the rise of substrate surface temperature during processing. This paper investigates the possibility of using an opto-elecironic sensor for in-process monitoring of clad quality. The experiments have revealed that clad bonding condition, clad porosity, clad uniformity (i.e. clad roughness, thickness variation and overlap consistency), substrate faults and system failure (e.g. nozzle clipping, lens cracking, powder feed failure ) etc. could be recognized by the optical signals from the melt pool radiation picked up by the sensor during processing. The use of the sensor for on-line laser cladding fault diagnostic and quality control is also discussed.

Paper Details

Date Published: 1 August 1990
PDF: 12 pages
Proc. SPIE 1279, Laser-Assisted Processing II, (1 August 1990); doi: 10.1117/12.20624
Show Author Affiliations
L. Li, Univ. of Liverpool (United Kingdom)
William M. Steen, Univ. of Liverpool (United Kingdom)


Published in SPIE Proceedings Vol. 1279:
Laser-Assisted Processing II
Lucien Diego Laude, Editor(s)

© SPIE. Terms of Use
Back to Top