Share Email Print
cover

Proceedings Paper

Novel surface treatment materials for aligning block-co-polymer in directed self-assembly processes
Author(s): Yasunobu Someya; Hiroyuki Wakayama; Takafumi Endo; Rikimaru Sakamoto
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

Directed Self-Assembly (DSA) process is one of the attractive processes for creating the very fine pitch pattern. Especially, the contact hole shrink processes with block-co-polymer (BCP) or polymer blend materials were attractive processes for creating very small size hole patterns with better CD uniformity compare to general photo-lithography patterning. In general contact hole shrink process, the pattern of Spin-on Carbon Hardmask (SOC) or the photo Resist pattern created by Negative-Tone Development (NTD) process were selected for guide patterns. Since the alignment property of BCP was affected by the surface of these guide materials, it is important to control the surface condition of guide in order to obtain good shrunk contact hole patterns. In this study, we will report the surface treatment materials to control the surface condition of guide patterns such as SOC or NTD resist to achieve the better contact hole shrink performance. These materials were attached to guide pattern surface and controlled the surface energy.

Paper Details

Date Published: 27 March 2014
PDF: 6 pages
Proc. SPIE 9051, Advances in Patterning Materials and Processes XXXI, 90510L (27 March 2014); doi: 10.1117/12.2046271
Show Author Affiliations
Yasunobu Someya, Nissan Chemical Industries, Ltd. (Japan)
Hiroyuki Wakayama, Nissan Chemical Industries, Ltd. (Japan)
Takafumi Endo, Nissan Chemical Industries, Ltd. (Japan)
Rikimaru Sakamoto, Nissan Chemical Industries, Ltd. (Japan)


Published in SPIE Proceedings Vol. 9051:
Advances in Patterning Materials and Processes XXXI
Thomas I. Wallow; Christoph K. Hohle, Editor(s)

© SPIE. Terms of Use
Back to Top