Share Email Print
cover

Proceedings Paper

A novel process for the fabrication of microstructures half the listed minimum feature size of a direct-write laser lithography system
Author(s): Robert A. Lake; Ronald A. Coutu
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

A method for fabricating structures half the size of the listed minimum feature size of a direct-write laser lithography system was demonstrated by taking advantage of the offset spacing allowed between write paths of the machine. This unique process allows microelectromechanical systems (MEMS) structures to be fabricated with minimum features smaller than equipment specifications. This method provides an increase in the capability of a lab without having to go through the cost and effort of re-tooling in order to provide the same capabilities. This ability will allow for the design and fabrication of structures, such as sensors, with an increased degree of sensitivity over those previously designed and fabricated with the same equipment. This new process resulted in 500 nanometer wide beams which half the size of the minimum feature size specified for our equipment.

Paper Details

Date Published: 7 March 2014
PDF: 10 pages
Proc. SPIE 8973, Micromachining and Microfabrication Process Technology XIX, 89730B (7 March 2014); doi: 10.1117/12.2037366
Show Author Affiliations
Robert A. Lake, Air Force Institute of Technology (United States)
Ronald A. Coutu, Air Force Institute of Technology (United States)


Published in SPIE Proceedings Vol. 8973:
Micromachining and Microfabrication Process Technology XIX
Mary Ann Maher; Paul J. Resnick, Editor(s)

© SPIE. Terms of Use
Back to Top