Share Email Print
cover

Proceedings Paper

Proximity effects in dry developed lithography for sub-0.35-μm application
Author(s): Anne-Marie Goethals; Ki-Ho Baik; Kurt G. Ronse; J. Vertommen; Luc Van den Hove
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

When printing at the resolution limit of the steppers, optical proximity effects become increasingly important and might limit the useful resist processing window. In this paper proximity effects have been studied for processes based on surface imaging and dry development. Proximity effect resulted in both linewidth and profile differences between dense and isolated lines at 0.35 micrometers and below. Proximity is partly due to optical effects (NA, (sigma) , wavelength, mask tonality) and partly due to processing conditions (silylation and development). To study the optical effects, aerial image simulations have been performed and a comparison with experimental results was carried out. Reduction in proximity is realized by a reduction in 'process offset', improvements in silylation contrast and a reduction in microloading effects during dry development. Positive tone resist processes show a reduced proximity effect as compared to negative tone resist processes and the feasibility for 0.30 micrometers dimensions has been shown. At 0.25 micrometers level, the process optimization should be accompanied with optical solutions in the form of selective mask biasing.

Paper Details

Date Published: 16 May 1994
PDF: 13 pages
Proc. SPIE 2195, Advances in Resist Technology and Processing XI, (16 May 1994); doi: 10.1117/12.175355
Show Author Affiliations
Anne-Marie Goethals, IMEC (Belgium)
Ki-Ho Baik, IMEC (Belgium)
Kurt G. Ronse, IMEC (Belgium)
J. Vertommen, IMEC (Belgium)
Luc Van den Hove, IMEC (Belgium)


Published in SPIE Proceedings Vol. 2195:
Advances in Resist Technology and Processing XI
Omkaram Nalamasu, Editor(s)

© SPIE. Terms of Use
Back to Top