Share Email Print
cover

Journal of Micro/Nanolithography, MEMS, and MOEMS

Limiting factors for electron beam lithography when using ultra-thin hydrogen silsesquioxane layers
Author(s): Anda Elena Grigorescu; Marco C. van der Krogt; Cees W. Hagen
Format Member Price Non-Member Price
PDF $20.00 $25.00
cover GOOD NEWS! Your organization subscribes to the SPIE Digital Library. You may be able to download this paper for free. Check Access

Paper Abstract

Isolated dots and lines with 6 nm width are written in 20-nm-thick hydrogen silsesquioxane (HSQ) layers on silicon substrates, using 100-keV electron beam lithography. The main factors that might limit the resolution, i.e., beam size, writing strategy, resist material, electron dose, and development process, are discussed. We demonstrate that, by adjusting the development process, a very high resolution can be obtained. We report the achievement of 7 nm lines at a 20-nm pitch written in a 10-nm-thick HSQ layer, using a potassium-hydroxide (KOH)-based developer instead of a classical tetra-methyl-ammonium hydroxide (TMAH) developer. This is the smallest pitch achieved to date using HSQ resist. We think that the resolution can be improved further, and is presently limited by either the beam diameter (which was not measured separately) or by the not-fully-optimized development process.

Paper Details

Date Published: 1 October 2007
PDF: 7 pages
J. Micro/Nanolith. 6(4) 043006 doi: 10.1117/1.2816459
Published in: Journal of Micro/Nanolithography, MEMS, and MOEMS Volume 6, Issue 4
Show Author Affiliations
Anda Elena Grigorescu, Technische Univ. Delft (Netherlands)
Marco C. van der Krogt, Technische Univ. Delft (Netherlands)
Cees W. Hagen, Technische Univ. Delft (Netherlands)


© SPIE. Terms of Use
Back to Top